Raise3D ESD Black Resin 1kg
Benefits
- Stable ESD property (105 – 108 Ohms/sq)
- Superior mechanical property (E-modulus: 3.0 GPa, UTS: 68 MPa)
- High resolution and surface quality
Applications
- Jigs & fixtures for electronics and automotive manufacturing
- Electronic housings, storage trays, electronic prototypes and parts
- Sensor mounting brackets, electrical connector housings, etc.
Material Properties*
*All test specimens were printed with Raise3D DF2 printer (405nm wavelength, 2.3mW/cm²,100 μm layer thickness, exposure time 7 seconds) and cured with DF Cure for 10 minutes per side at room temperature.
See more details in Technical Data Sheet.
| Testing Method | Green | Post-Cured | |
| Tensile Strength | ASTM D638 | 41 MPa | 68 MPa |
| Young’s Modulus | ASTM D638 | 1.9 GPa | 3.0 GPa |
| Elongation at Break | ASTM D638 | 13% | 6% |
| Flexural Strength | ASTM D790 | 43 MPa | 126 MPa |
| Flexural Modulus | ASTM D790 | 1.7 GPa | 3.0 GPa |
| Notched Izod | ASTM D256 | 23 J/m | 28 J/m |
| Heat Deflection Temp.@0.45 MPa | ASTM D648 | N/A | 76°C |
Cleaning
ESD resin requires cleaning to achieve the desired surface effect. It is not necessary to remove the support structure from the printed part before cleaning. The printed part should be cleaned before post-curing until there are no solvent residues on the surface. For special structures or fine details, such as small holes, it is recommended to wash manually, then use compressed air or nitrogen to blow off the residual solvent on the surface, or leave the print to dry at room temperature for a short time until there is no solvent residue on the surface before post-curing.
For recommended washing parameters using Raise3D DF Wash, please refer to the following table:
| Wash Time | Wash Drying Time | |
| Recommended washing parameters | 5 min | 10 min |
Post-curing
After cleaning, ESD resin parts require post-curing to achieve optimal performance. Please refer to the post-curing parameters for Raise3D DF Cure in the table below.
| UV Curing Time | Heat Curing Time | Heat Curing Temperature | |
| Setting 1 | 20 min | 0 min | N/A |