Raise3D Draft Grey Resin 1kg
Benefits
- Fast printing speed
- High printing success rate
- Low viscosity
- Smooth surface
- Easy to clean
Applications
- Rapid prototypes validation
- High throughout parts
- Industrial design parts
- Art and sculpture display parts, etc
Material Properties*
*All test samples are printed on Raise3D DF2 printer (405nm wavelength, 2.3mW/cm², 200 μm layer thickness, exposure time 5 seconds) and cured for 10 minutes on the front and back of the sample with DF Cure.
See more details in Technical Data Sheet.
| Testing Method | Green | Post-Cured | |
| Tensile Strength | ASTM D638 | 27.7 MPa | 56.5 MPa |
| Young’s Modulus | ASTM D638 | 0.95 GPa | 2.9 GPa |
| Elongation at Break | ASTM D638 | 16.7% | 8.31% |
| Flexural Strength | ASTM D790 | 61.2 MPa | 98.1 MPa |
| Flexural Modulus | ASTM D790 | 1.67 GPa | 3.3 GPa |
| Notched Izod | ASTM D256 | 18.0 J/m | 18.4 J/m |
| Heat Deflection Temp.@0.45 MPa | ASTM D648 | 49°C | 96°C |
Cleaning
Draft Grey Resin requires cleaning to achieve the ideal properties of the printed part.
There is no need to remove support structures from the printed part, and the part should then be washed before post-curing, until the surface is free of any solvent residue.
For special structures or fine details, such as small holes, it’s recommended to clean manually, then blow dry the part with compressed air/nitrogen to remove residual solvent from the surface, or leave the part for a short time at room temperature to dry. Post-cure the model until the surface is free of any solvent residue.
Please refer to the chart on the right for the recommended washing parameters with Raise3D DF Wash.
| Wash Time | Wash Drying Time | |
| Recommended washing parameters | 5 min | 10 min |
Post-curing
After cleaning, Draft Grey parts require post-curing to achieve optimal properties. Please refer to the chart on the right for the parameters with Raise3D DF Cure.
| UV Curing Time | Heat Curing Time | Heat Curing Temperature | |
| Setting 1 | 20 min | 0 min | N/A |