Raise3D Rigid 3K Grey Resin 1kg
Features
- 3263 MPa Young’s modulus
- 78 MPa tensile strength
- 97°C HDT @ 0.45 MPa
- 30 J/m Izod notched impact
Benefits
- High rigidity
- Excellent part strength
- Heat resistance
- Rigidity similar to glass fiber reinforced thermoplastic materials
Applications
- Robust prototypes
- Thin-wall parts
- Jigs & fixtures
- Connectors
- Mounts and brackets
Material Properties*
*All test specimens were printed with Raise3D DF2 printer (2 mW/cm2 at 405 nm, 100 μm thickness, 5.5s) and cured with DF Cure for 30 minutes per side at room temperature.
See more details in Technical Data Sheet.
| Testing Method | Green | Post-Cured | |
| Tensile Strength | ASTM D638 | 38 MPa | 78 MPa |
| Young’s Modulus | ASTM D638 | 1766 MPa | 3263 MPa |
| Elongation at Break | ASTM D638 | 30% | 14% |
| Flexural Strength | ASTM D790 | 52 MPa | 139 MPa |
| Flexural Modulus | ASTM D790 | 1278 MPa | 3252 MPa |
| Notched Izod | ASTM D256 | 24 J/m | 30 J/m |
| Heat Deflection Temp.@0.45 MPa | ASTM D648 | N/A | 97°C |
Compare Resins Properties
Compare the resins‘ properties, and find the one that best meets your requirement.
Cleaning
Rigid 3K Grey V1 Resin requires cleaning to achieve the ideal properties of the printed part.
There is no need to remove support structures from the printed part, and the part should then be washed before post-curing, until the surface is free of any solvent residue.
For special structures or fine details, such as small holes, it’s recommended to clean manually, then blow dry the part with compressed air/nitrogen to remove residual solvent from the surface, or leave the part for a short time at room temperature to dry. Post-cure the model until the surface is free of any solvent residue.
Please refer to the chart on the right for the recommended washing parameters with Raise3D DF Wash.
| Wash Time | Wash Drying Time | |
| Recommended washing parameters | 10 min | 10 min |
Post-curing
After cleaning, Rigid 3K Grey V1 parts requires post-curing to achieve optimal properties. Please refer to the chart on the right for the parameters with Raise3D DF Cure.
Setting 1: For prototyping uses.
Setting 2: To achieve the best resin properties, as indicated in the TDS (default parameters in ideaMaker).
| UV Curing Time | Heat Curing Time | Heat Curing Temperature | |
| Setting 1 | 10 min | 10 min | 70℃ |
| Setting 2 | 60 min | 0 min | N/A |